![]() This is typically easiest and quickest to do by hand and simply pulling the leaves down against the grain or plucking them out of the flowers. Now we will remove the fan or water leaves.First remove the main branches from the stock, next individualize the stems from the main branch. We first want to prep the plants for trimming.It’s important to have a work space that will accommodate the components as well asĪllow you to keep the flex shaft cable and vacuum hose straight as you’re trimming both for ergonomics as well as minimizing friction within the flex shaft.The electric handheld cannabis trimmer is now ready for use.Water (the crock pot can be used to dip the wand in while trimming to clean the Optionally you can purchase a small crock pot and fill it with water and heat the.Moisten the second sponge, this sponge will be used to clean the outside of the.Fill one of the rectangular compartments with the sponge with water until the sponge has absorbed the water and the reservoir is half full (this moist sponge will be used to lubricate the inside of the wand while trimming helping to reduce build up).Open the sponges and place them in the rectangular compartments atop the tool box.Plug the wand power cord into the back of the motor control box and into a power.Plug the vacuum power cord into the vacuum suction controller (do not plug the wand motor into the vacuum suction controller).Attach the other end of the vacuum to the hose on the wet/dry vacuum.Lay the vacuum hose along side the flex shaft cable and attach it to the flex shaftĬable using the provided velcro straps, attach a velcro strap every 8-10 inches (zip.Wand (the first few times may take a little more effort) Install the open end of the vacuum hose to the vacuum hose attachment on the. ![]() Shaft until it clicks (the wand should rotate freely when it is connected to the cable) Once the keys are aligned, continue rotating and press the wand down on the flex.Rotate the wand without pressing in to assist the keys alignment.Attach the wand to the end of the flex shaft cable by aligning the keyed end of theĬable with the key at the base of the wand in the drive hub housing.Place the motor at one end of the table (on the right side if you are right handedĪnd the left side if you are left handed).Remove the wand, motor, vacuum hose, vacuum suction controller and velcro.Free shipping on all orders totalling over $100.A 30% discount will be applied to all future orders.Free shipping on all orders totalling over $250.A 25% discount will be applied to all future orders.Free shipping on all orders totalling over $500.A 20% discount will be applied to all future orders.Free shipping on all orders totalling over $2,000.A 15% discount will be applied to all future orders. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |